Get to know in detail about Vin Verification
The reason why this number is sometimes difficult to decipher is that these engines have been stamped by hand and punched on a rough surface. I determined, according to the numbers, that the engine was a 425-horsepower high-performance engine with a manual 4-speed transmission. Have a look at QUICK VIN VERIFICATION – dmv vin verification more info on this.
The last numbers corresponded to the last numbers in my VIN as well, which meant that this was the car’s original engine. The numbers told me that the engine was assembled on the 14th of June, which was in line with the date of construction. With a rag and brake cleaner, the engine block part number that is cast into the rear of the block has also been cleaned. A high-performance block used for Camaros was identified by the block part number. A further piece of the puzzle has been confirmed.The numbers are stamped on the top of the right axle tube on the rear axle of the Camaro. It was my experience that this region is usually pretty crusty and rusty. And there was no exception with this rear axle. I wiped the area clean with the brake cleaner after considerable wire brushing. Lying on my back, while I was holding a mirror, I shone a light over the area. It was still not sufficiently clear for me to read correctly. Then I picked up my grease pencil and ran it across the numbers. The purpose of the grease pencil is to provide a contrast between the axle tube and the metal. I was rewarded with a very sharp picture of the part numbers when I put the mirror back over the region, which I copied into my notebook. According to the numbers, the gear ratio for this rear axle assembly was 4.10:1, limited slip. On June 16, 1969, the axle was assembled. Do you see a pattern here that is beginning to appear? Based on the date codes referencing the construction date of June 1969, the axle numbers also indicated the axle to be original to the vehicle. With the other components, I have taken the same approach.